TY - GEN
T1 - Flowmeter based on capillary tubes trough 3D stereolithography fabrication for test mechanical ventilation equipment
AU - Gutarra, Jafet Daniel Santivanez
AU - Laureano, Jose Luis Mantari
N1 - Publisher Copyright:
© 2022 IEEE.
PY - 2022
Y1 - 2022
N2 - Mechanical ventilators and high-flow machines are medical devices with important measuring instruments for monitoring patients with respiratory failure. The most common monitoring parameters are lung proximal pressure, inspiratory flow, expiratory flow, inspiratory oxygen fraction, etc. The present work delves into the design, fabrication, and experimental measurement of a proximal flow sensor based on the theory of capillary tubes and stereolithography. The design was carried out in Inventor Professional 2020 software and then the computational study by CFD ANSYS to compare the dynamic pressure states of the geometric measurement points. The manufacturing was carried out using SLA 3D printing technology on an ANYCUBIC FHOTON MONO X.The fabricated FM SLA prototype has radially positioned latex tubing lines to achieve differential pressure measurement at two points separated by capillary tubes. These hoses are connected to a developmental embedded system based on a HONEYWELL 001PG7A5 differential pressure sensor and Arduino Uno Microcontroller. Finally, experimental tests of the Flow Meter Stereolithography (FM SLA) protype measurements were performed with flow rates from 0 to 44.5 lpm in 1 lpm increments. From the collected data we have an R2: 0.9983 in quadratic polynomial approximation with the actual measurement data.
AB - Mechanical ventilators and high-flow machines are medical devices with important measuring instruments for monitoring patients with respiratory failure. The most common monitoring parameters are lung proximal pressure, inspiratory flow, expiratory flow, inspiratory oxygen fraction, etc. The present work delves into the design, fabrication, and experimental measurement of a proximal flow sensor based on the theory of capillary tubes and stereolithography. The design was carried out in Inventor Professional 2020 software and then the computational study by CFD ANSYS to compare the dynamic pressure states of the geometric measurement points. The manufacturing was carried out using SLA 3D printing technology on an ANYCUBIC FHOTON MONO X.The fabricated FM SLA prototype has radially positioned latex tubing lines to achieve differential pressure measurement at two points separated by capillary tubes. These hoses are connected to a developmental embedded system based on a HONEYWELL 001PG7A5 differential pressure sensor and Arduino Uno Microcontroller. Finally, experimental tests of the Flow Meter Stereolithography (FM SLA) protype measurements were performed with flow rates from 0 to 44.5 lpm in 1 lpm increments. From the collected data we have an R2: 0.9983 in quadratic polynomial approximation with the actual measurement data.
KW - 3D printing
KW - Covid-19
KW - Flowmeter
KW - Mechanical Ventilation
KW - stereolithography
UR - http://www.scopus.com/inward/record.url?scp=85138777230&partnerID=8YFLogxK
U2 - 10.1109/INTERCON55795.2022.9870053
DO - 10.1109/INTERCON55795.2022.9870053
M3 - Conference contribution
AN - SCOPUS:85138777230
T3 - Proceedings of the 2022 IEEE 29th International Conference on Electronics, Electrical Engineering and Computing, INTERCON 2022
BT - Proceedings of the 2022 IEEE 29th International Conference on Electronics, Electrical Engineering and Computing, INTERCON 2022
PB - Institute of Electrical and Electronics Engineers Inc.
T2 - 29th IEEE International Conference on Electronics, Electrical Engineering and Computing, INTERCON 2022
Y2 - 11 August 2022 through 13 August 2022
ER -